For a desktop setup the touchscreen comes with two supporting brackets.
Frontpoint control panel wall mount.
The hub and keypad are pre programmed and ready to connect to your network and devices right out of the box.
Remove the triangular shaped tabletop stand to expose all needed screw holes.
Make sure the sensor is mounted with the arrow pointed towards the ceiling.
For a wall mount setup the touchscreen comes with wall mounting bracket and screws.
This countdown is called the entry delay which is the amount of time you have when entering the home to disarm the system by entering your 4 digit code into the control panel.
Every frontpoint system uses the frontpoint hub and keypad as the central command center.
There are no phonelines to cut the system is.
Use the appropriate screws not included to mount the base plate to the wall remount the panel onto the hinge and close the panel.
Two included adhesives to adhere it flat against the wall or in a corner or you can place it directly on a shelf.
The control panel serves as the nerve center for your system.
The hub and keypad are pre programmed and ready to connect to your network and devices right out of the box.
Once the control panel is fully armed and a door sensor is tripped the control panel will beep for 30 seconds.
All frontpoint systems come with a wall mounted or tabletop controller that serves as your primary interface.
The hub is the brains of your alarm system and the keypad is how you control it.
Every frontpoint system uses the frontpoint hub and keypad as the central command center.
You can arm and disarm the system from the panel check the weather view sensor status.
Here you ll find everything you need to set up and get familiar with your frontpoint system.
Yes your control panel can be mounted on a flat wall surface using size appropriate screws.
Before mounting the panel to a wall.
The hub is the brains of your alarm system and the keypad is how you control it.
Www frontpoint com help a b c do not mount sensor directly on a window glass break sensor.
Www frontpoint com help control panel it all starts here.
Close the door and mount tilt sensor on the door.
Touch screen control panel.
Keep note of the red battery wires and ac wires both should be going out through an oval or square hole on the back plate.
They run on a 100 cellular connection with a built in wi fi backup.
From the frontpoint app test opening the door with the tilt sensor mounted.
The touchscreen control panel has desktop setup and wall mounting options.
Test opening the door from frontpoint app again.
Attach the brackets then place the device where you want it.
Get your system up and running starting with your control panel.
